1. Drop test on large furniture, desks, chairs, and other test pieces. Specifications can be customized. Selection features: digital display height, electric lift, electric double arm synchronization / reset. The distance between the two columns is adjustable, and it can also be used for single arm drop. Second, the use standard of the drop test machine 1. After each test is completed, the drop arm needs to be dropped to prevent the long-reset drop arm from pulling the spring and deforming it, which affects the test effect. Each time you drop the money, please reset the position and stop the motor before pressing the drop button. 2. After the new machine is installed at the factory, it is necessary to add low-concentration engine oil to the sliding round bar. It is strictly prohibited to add anti-rust oil or high-concentration engine oil and corrosive oil with backlog. 3. If there is too much dust in the oiling place for a long time, please lower the machine to the bottom, wipe the previous engine oil and re-oil. 4. The drop machine is an impact mechanical device. When the new machine is used more than 500 times, it is necessary to tighten a screw to avoid failure. 5. The lifting shaft and chain of the testing machine need to be lubricated regularly. 6. The gear reducer changes oil transmission every six months. 7. Please test at a room with low humidity (no condensation below 80%) and a place with little dust and dust. 8. In order to prevent the machine from losing control during the operation and cause accidents and electric shock, please be sure to turn off the power before performing the operation. Keep the lifting shaft clean. 9. Non-operating personnel shall not operate the machine arbitrarily. 3. Model parameters of the drop test machine 1. The drop height range is generally 400mm to 1500mm 2. The allowable range of the test piece is (length * width * height) 3000mm * 2000mm * 1500mm 3. The maximum load is 300 kg 1. The drop height range is generally around 300-1500mm 2. The height setting range is less than or equal to 2% of the set value 3. The maximum load should reach 100 kg 4. The error of the drop angle is less than or equal to 5 ° 5. Motor power 1 / 2HP 4. Choose the zero-drop test for packages (dropping at lower heights of diamond, surface, and cross). The drop height starts from zero. In the double-column direction, hydraulic buffer, drop height can be set. 1. The drop height is generally 0 to 1000mm or higher 2. The maximum load is 200 kg 3. The maximum size of the test piece is about 1000mm ★★★★★★ ★★★★★★ ★★★★★★ ★★★★★★ ★★★★★★ ★★★★★★ ★★★ Aisi Lili-rubber / shuo rubber / toy industry test box manufacturing expert, Taiwan brand drop test machine, top technology! Main products: rubber toy high and low test box, Shuo rubber toy constant temperature and humidity box, Shuo rubber toy fast Temperature change box, rubber toy accelerated aging test box and other quality testing equipment, excellent quality, reasonable price, what industry and test conditions is the drop test machine suitable for Strider Balance Bike,Best Balance Bike,Wishbone Bike,Wooden Balance Bike ANDER LEISURE PRODUCTS CO.,LTD , https://www.anderbike.com