Production process First, the height of the platform: Electric lift platform height = wire tube keel + lift +2.5-3 cm desktop +1 to 2 cm adjustment gap + tatami mat thickness is generally 5 cm (not considered if tatami mat is not installed) Floor height of manual lift = lift floor + lift + 3 cm thick table +1 to 2 cm adjustment gap + tatami mat thickness is generally 5 cm (not considered if tatami mat is not installed) Second, the size of the desktop To combine the user's situation with the length and width of the platform, the following formula can be used: (Room width - desktop width) ÷ 2> 45 cm (lower comfort when the table is raised to the side of the wall less than 45 cm) The recommended size is 80--90 cm square (can be made in the range of 70---100 cm) Extended reading: tatami material and shopping points Third, if the tatami mat is to be installed on the platform , the baffle should be made as shown above. Fourth, in addition to protecting the edge of the tatami, the wall baffle has the function of adjusting the rules of the platform. Solve the straightness of the wall, the size of the head, so that the plane of the platform can be square. Its width is not a fixed number, depending on the material and the wall. The height is based on the thickness of the tatami mat, and the usual mat thickness is 5 cm. 5. The weight of tatami itself is 15 kg/m2 . If it is made into a storage cabinet, it will be difficult to open and close. Therefore, at the time of production, if the length of the cabinet is more than 1.2 meters, a light-weight paulownia board or finger joint board can be placed under the cabinet board, and a pneumatic strut can be installed to assist. Extended reading: tatami decontamination and maintenance methods Sixth, the upper deck board can not be used as a handle on the board surface , and can be made into a concave or a boring hole, or a cloth belt can be fixed under the cabinet board to open. Seventh, the weight bearing of the platform is the key , so the span (width) of the box is not easy to be too large, and the control is beneficial between 50-80 cm. And lining the wooden or other lining under the cover as the case may be. 8. The floor of the tatami mat should be installed . If the length and width are allowed during the production, it can be made into a square, preferably made square, or at least two or more are the same size. Tatami mats will wear out after all, but each tatami mat will be used at a different frequency. If there are several tatami mats of the same size, they can be replaced according to the wear and tear. Nine, do not forget to put the power cord of the box under the bottom plate with the electric lift . And open the outlet hole on the bottom plate. It is best to install a manual lift and also leave a power outlet in the lift. 10. The maximum size of a tatami mat is 2 meters x 1 meter . When making the floor box, it must be controlled within this size. The lifts are available both manually and automatically. Manually about 500~1000, automatic 1500~2000 or so. Extended reading: small apartment decoration tatami taboo Banding Machine can use "paper tape" or "opp tape" to pack, and use hot-melt bonding to make the product packaging simple and beautiful. Suitable for paper products, medicines, cosmetics, electronic products and general light goods. It can also be matched with the conveyor belt according to the production needs to achieve unmanned packaging. To achieve the goal of saving manpower and improving packaging quality Banding Machine Banding Machine,Pallet Banding Machine,Plastic Banding Machine,Automatic Banding Machine Jining Myway Machinery Co., Ltd. , https://www.mwpackall.com
